When the conveyor roller is in use, it is also necessary to pay attention to see if the belt tightness is appropriate and adjust the tensioning device in time; during the operation of the conveyor roller, also pay attention to check the motor, gearbox, transmission gear, bearing bush, Couplings, transmission belts, rollers, rollers, etc. are normal; all parts of the conveying roller must be firmly connected without cracks, deformation or abnormal noise.

For the use of the conveying roller, please note that the sequence when starting up is to start sequentially from the unloading end to the feeding end. When the conveying roller is started, we must also pay attention to a cycle of idling. After inspection, the parts can run with load. After the conveying roller is running, the operator must focus on his position, and the belt driver must always follow the line. Inspect, find problems, and eliminate them in time.

When the conveyor roller is often used, it is also necessary to pay attention to frequently check the grounding protection and insulation of this electrical equipment. Regarding the motor, it should also be measured and inspected by instruments and regularly maintained. When the equipment is running, it is strictly forbidden for anyone to walk across the belt, and it is forbidden to ride on a belt, etc.

When using the conveyor roller, pay attention to cleaning the dirt on the belt roller frequently. It is strictly forbidden to clean the triangle grill, shovel and wooden stick without stopping. The feeding to the conveyor roller belt must be uniform to prevent excessive feeding and crush the belt, affecting the safe operation of the machine.

When the conveyor roller is in use, it is important to pay attention to the prohibition of heavy vehicle parking (except for emergency incidents); if there is a sudden power outage, you should pay attention to immediately cut off the conveyor roller's power supply; Before stopping, first stop feeding, wait until the material on the conveyor roller belt is completely unloaded, then signal the shutdown. When multiple belts are connected in series, the shutdown sequence is from the feeding end to the discharging end.